I moved my business into a new building, and there is a doorway i want to put up a door in it. However the doorway is about 1/4" narrower at the bottom, than the top. Neither of the top corners are square. I am looking for the easiest way with the least amount of work and knowledge needed to hang this door. It is only a barrier, it is not for security. It will be closed most of the time, so i am not worried if it is going to naturally swing open or closed.

Also, the cuts for the hinges on the door and the frame do not line up. I am fine with buying a new door, but I would rather not replace the frame of i can avoid it.

Any suggestions?

  • EchEnglish
    32·
    1 month ago

    Have you tried using Flicker? Might come back all fixed. If that doesn’t work you could use Disenchant and just get a new door all together.

    • nocturne@sopuli.xyzOP
      2·
      1 month ago

      I was thinking of trying an o-ring on the door way and starting over. Maybe a Swords to Plowshares, since it is a wall I likely do not have to worry about the life gain.