Hi folks, I’ve had my ender 3 v2 for around 2 years and it’s been trouble-free until lately. Recently, I’ve had major issues with the first layer. I found a few worn components, so I got a dual gear extruder and replaced the nozzle, recald the esteps, bed level and z offset. Nothing I do seems to work.

The issue happens on the first layer when it first starts to extrude. The first 5mm or so of extrusion curls up behind the nozzle, then the extrusion sticks to the bed and it continues normally… Until it needs to starts a new extrusion, then the same thing happens…the curl.

I have to think it’s something with temperature, but I haven’t changed anything about the filament since these issues started.

Looking for any advice. Thanks!

  • edjsage
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    This. Finger oils are the enemy. If you’ve never washed the bed with soap and water, it usually fixes adhesion issues on a properly leveled machine.

    • Drudge@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      ok ok, I’ll put the old bed on after I wash it real good…I do this periodically but maybe I was eating chips or something.

      • Drudge@lemmy.worldOP
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Gahhhh same thing… I’m on day 4 of this bs. I’m gonna throw my printer out a window

        • Rolivers@discuss.tchncs.de
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          It looks like your Z offset is too high. I think you calculated in the wrong direction. Your Z offset should be so that if you go to Z 0 then your nozzle would just barely hit the bed.

          Don’t give up!

        • 𝑔𝑎𝑙𝑎𝑥𝑖
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          Glass is really hard to stick to. You’ve gotta get the z axis just right. I know it was working before but it happens. Don’t give up but definitely take a break if you need. Highly recommend putting down some purple gluestick, it helps a ton. It isn’t your fault if you’ve cleaned the bed, it’s gonna take some patience. Maybe look into getting a PEI sheet if you don’t have one? There happens to be a limited time deal on one your size (235x235mm, ender 3 v2 and aquila are the same) on amazon for $10: https://a.co/d/emfbtnc

          Not a referral link or anything, but I really recommend one. They’re usually around $15-20. I haven’t touched my glass bed since I got one. Other than that honestly dude just go back when you’ve got more patience and download a bed leveling test print, and keep tweaking.

          • edjsage
            link
            fedilink
            English
            arrow-up
            1
            ·
            1 year ago

            A little aqua net hairspray will do the trick too.