Hi everyone! Recently I have gotten interested in communication protocols and have been looking for one (with little success, hence my question) which would satisfy the following requirements (in prioritized order):

• All devices should be able to initiate communication (not your typical master slave with polling)

• Devices should be able to address messages directly to one another without a single one permanently taking on some host/master/relay role

• Devices should be hot-pluggable (A new device may be connected to the network or removed from it without problems even when the network is up and running)

• The protocol should be stable and immune enough to noise so that it can be sent through wires up to at least 5 meters, ideally even up to 10-50 meters.

• It should be simple, implementable even on low-perfomance microcontrollers.

• It should have its maximum transfer rate in the kilobytes per second range or preferably even megabytes per second.

I have looked at I2C, which for the most part would be fine, but as far as I understand it was not meant to be sent through a wire and it would be quite vulnerable to interference. (It also is by default a master-slave protocol, but it also has a multi-master mode, so maybe making every device a slave and a multi-master master at the same time could work?)

The rest of the protocols I looked at were all master-slave, which, for my purpose, is unacceptable.

That being said, I would be grateful if you could give me some pointers as to what protocol may satisfy these requirements and perhaps even on what sort of wires and signals it would require (twisted pairs? Differential signal? Shielded twisted pairs? Could plain simple wire suffice? etc.)

  • oldfart
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    Exactly, hard/easy depends on your background. It’s been almost 20 years since I worked with it, I’m sure there are ready made libraries or chips implementing 99% of the protocol these days.