This is the base of a pumpkin. There is a little support where the over hang is a bit much to start. How did I get great smoosh on the support but not the first layer of the actual print?! They’re the same layer!

  • FuglyDuck@lemmy.world
    link
    fedilink
    English
    arrow-up
    21
    ·
    1 year ago

    I’m not entirely sure what’s going on… I’d have to check the model (and even then… slicers can do things weird).

    That said, my guess is that the model’s base isn’t perfectly flat it looks like it tried to generate some rafting, but was too close or something to generate proper support.

    My advice is to check the gcode in your slicer- that’ll show you if it’s a gcode issue or a printer issue.

    If it’s gcode, try raising it by 1mm off the plate and tell it to generate support every where. If you’re using Prusa slicer, maybe consider the tree supports

    • Uninvited Guest@lemmy.ca
      link
      fedilink
      English
      arrow-up
      22
      ·
      1 year ago

      I was going to suggest the opposite - lower the model .5 mm in to the platter to cut a clean bottom and ensure it’s flush.

      • FuglyDuck@lemmy.world
        link
        fedilink
        English
        arrow-up
        4
        ·
        edit-2
        1 year ago

        that works too, assuming it lowers it enough to get a sizeable patch. either way will get a decent print. They’re already printing with supports, however, so the loss in quality from janky support removal isn’t in play.

        (ah crap. Sorry for the pun.)