- cross-posted to:
- 196@lemmy.blahaj.zone
- cross-posted to:
- 196@lemmy.blahaj.zone
You must log in or register to comment.
deleted by creator
Not only that, the detailed title underline isn’t a straight line. It’s unevenly curved.
deleted by creator
This is fantastic! You’re a drawing checker/approver aren’t you?
deleted by creator
There’s also no material control for the entire drawing. If there’s alternative woods permitted, does that affect your nail selection. This drawing seems ripe for a Design Variations Table.
deleted by creator
until flat end is flush
Gonna need a tolerance on that. Flush +/- .020" sounds good.
surface of wood
Is any wood acceptable? There’s a significant difference between birch and oak.
What about things that share a similar property to wood? Say, a duck, or a witch, or a great gravy?
Or very small rocks?
deleted by creator
That feel when your gravy is more dense than the meatloaf you’re pouring it on.
It appears that a wood grain is shown which I think would indicate it is important and requires a label.
Looks like all the easy definitions have been taken care of by others.
More GD&T always drives the floor jockeys piping hot mad, so do that to excess. Position at MMC, angularity, flatness of the nail head, give them the beans.
However, Having also worked with enough plant floor people-
If you don’t have a separate view showing the fully installed configuration you are wasting your time with all those notes. Nobody gonna read them.
deleted by creator
You’re… not that far off tbh. They’re not stupid, far from it, and they’re crazy efficient, but they just do not have that refined skill of translating an implied picture into a real one. That takes a lot of practice.
That’s OK tho. It’s my job to make it as obvious as possible so such problems don’t happen.
deleted by creator
There’s lots more stuff you could include. For example:
- indication of which part of the hammer should be used to strike the nail
- recommended angle of entry for the nail to penetrate the wood
- recommended angle of impact for the hammer against the head (once correct part of hammer is indicated)
- scale: how long/thick is the nail? How thick/deep is the piece of wood? Is the illustration to actual scale, or is it a more general representation of the objects?
- material composition of nail
- type and density of wood
- grain direction of wood
- is the diagram indicating relative positioning, or absolute? For example, does the wood always need to be parallel to the ground, and does the nail always need to be perpendicular to the ground.
- description of variances with respect to types of nail heads; some may have squared edges, others may be beveled.
I could keep going, you get the idea.
Very thorough! The material compositions are my first go to.
Then the marketing and graphics design team gets it, and it reads “hit nail”.with a graphic that may or may not show to hit the nail on the side of the nail.
deleted by creator
Add a couple of +/-0% here and there just to irritate haha
Remove fingers?
Sigh, fucking engineer never said Id need boltcutters. Lucky Im smart enough that I came prepared.
SNIP
SNIP
SNIP
