When I started soldering everything was big and had leads that went through holes in the board. You inserted the leads, bent them over to hold the component, flipped the board over, soldered everything, and trimmed off the excess leads.

Now I’m soldering things down to 0402 SMDs (1/4 the size of the smallest component in the picture) using a needle point soldering tip and a microscope.

A pair of 2N2222 transistors, one SOT23 and one TO-92.

  • VanillaGorilla@kbin.social
    link
    fedilink
    arrow-up
    3
    ·
    1 year ago

    True. I mean you can still find most parts that you used 45 years ago, but making it small and using modern parts might require some new tools. You can get a tiny hot plate on Ali for cheap, but I’m not sure how good it is. There are people utilizing cheap irons as well.

    • Saturdaycat@kbin.social
      link
      fedilink
      arrow-up
      2
      ·
      1 year ago

      Are there good instructions out there for people using cheap irons to solder these small components? How does one get into soldering now with a hot plate vs hand iron considering that these components have a much higher learning curve than the older larger parts ?

      • Chreutz@lemmy.world
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        If you want to do really low investment hot plate soldering, some solder paste, good tweezers and a frying pan with some sand in it is probably good. Just keep an eye on it while heating, and stop when the solder melts

      • ______
        link
        fedilink
        arrow-up
        2
        ·
        1 year ago

        The cheap soldering irons are tricky because heat distribution is crucial. If your iron is not at the right temperature and the heat transfer is not uniform you can fry a component instantly, specially the smaller components. you need a soldering iron with temperature dials at bare minimum

      • MapleEngineer@lemmy.caOPM
        link
        fedilink
        English
        arrow-up
        2
        ·
        edit-2
        1 year ago

        I’m working on making some videos to show what can be done with basic equipment even with modern, small components. Maybe I should add some soldering 101 type videos? I can add them to my YouTube channel for my 6 subscribers. Heh.

        EDIT: 9! 9 subscribers! Pretty soon I’ll be able to quit my day job and live off my YouTube channel.

    • MapleEngineer@lemmy.caOPM
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      I’ve seen the tiny ones. I think I’m more likely to build a small reflux oven. I only ever build one or two of anything unless I take in a job for someone else.