• CptEnder@lemmy.world
    link
    fedilink
    English
    arrow-up
    8
    arrow-down
    1
    ·
    3 months ago

    Also stealthy af and much much higher torque ratios.

    Only problem is current SOP for technical vehicles in most modern a armies is to be run and used continuously for days on end without contact with supply lines. If they can create E-Jerry Can modular batteries and some sort of mobile generator refueler then hell yeah. Otherwise liquids strapped to the side of everything is gonna be more effective.

    • skulblaka@startrek.website
      link
      fedilink
      English
      arrow-up
      2
      arrow-down
      1
      ·
      3 months ago

      E-Jerry Can modular batteries

      We’ve already established that weight isn’t really an issue so let’s just give it two battery racks. It runs off one battery at a time so the other one can be disconnected and changed. When the one in use runs low, throw the breaker over and either change the dead battery or keep running on the aux until that one dies too if you’re in an emergency situation.

      Larger vehicles with higher power requirements can scale up the number of battery racks they have and still use the universal Grunt Power Brick just in larger quantities, and you can create a battery hauler with a generator and like 40 battery slots to carry around your fresh ones and recharge your empties. That generator might be the one thing in your squadron that still runs on gasoline, supplemented with solar.

      • brianorca@lemmy.world
        link
        fedilink
        English
        arrow-up
        3
        ·
        3 months ago

        There’s no such thing as needing to disconnect while charging, unless you literally leave the battery behind somewhere. If you have two batteries on board, then you can use them in parallel.

        • skulblaka@startrek.website
          link
          fedilink
          English
          arrow-up
          3
          ·
          3 months ago

          Yes but this way you can hot swap in a fully charged battery from your carrier unit without needing to power down the vehicle. You could use both batteries in parallel, but the proposed solution minimizes charging time on any given machine by sourcing it all out to the carrier and allowing constant uptime of the target vehicle by never leaving it with two dead batteries.