I’ve been using gyroid infil almost exclusively since I first tried it.

I was using cubic before, which was fine, but gyroid seems much sturdier for the same % infil even if it does take a bit more print time.

Also it looks awesome.

  • 4lan@lemmy.worldEnglish
    3·
    10 months ago

    Thanks! It’s fun to mix both skills into one project.

    Here is how they turned out

        • JtskywalkerOPEnglish
          1·
          10 months ago

          I thought so but I’ve only ever used it on taller TPU prints where I want them to basically be hollow so I’ve never seen it look quite like that!

          • 4lan@lemmy.worldEnglish
            2·
            10 months ago

            fairly high infil percentage if I remember correctly. I did 20% first and it was very sparse